How to maintain the lobe pump manufacturer's lobe pump?
2022-10-21 17:24:08
Read:
Share:
Because of the use of the CAM lobe pump manufacturer's disc motor rotor, in addition to the characteristics of the general CAM pump, it has certain advantages in the transport of low viscosity and contains relatively large particles of raw materials, especially the thick raw materials can be reasonably transported. How to carry out maintenance of CAM lobe pump in daily life? CAM lobe pump maintenance and maintenance 1. Check whether the CAM lobe pump, pipe and joint are falling off. Rotate the lobe pump by hand to observe whether the CAM lobe pump is flexible. 2. The amount of oil should be observed at the oil standard bottom shaft, and the grease should be replaced or filled immediately. 3. Start the motor, and see if the motor rotation is normal. 4. As far as possible to manipulate the total flow rate and head of the CAM lobe pump in the range marked on the logo, to ensure the normal operation of the CAM lobe pump, can get a large practical effect of energy saving and environmental protection.
5. In the operation of the CAM lobe pump, the rolling bearing temperature can not be higher than the natural environment temperature of 35℃, the temperature can not exceed 80℃. 6. If the CAM lobe pump is found to have abnormal sound should immediately stop to check the reason. 7. Adjust the packing screw cover often to ensure that the dripping condition in the packing room is normal (it is advisable to make the dripping out). 8. When the CAM lobe pump is applied in winter, after stopping, it is necessary to add water to the pump shell to avoid freezing and breaking. 9. The CAM lobe pump for a long time to stop use, need to remove all the pump, wipe the moisture, the rotating position and the joint coated with plant grease, properly stored.
