The CQ series stainless steel magnetic pump is the best equipment for moving flammable, explosive, toxic, and rare liquids. It is also the best option for building a clean, leak-free, and leak-proof workshop. Made of stainless steel overflow parts, this pump is widely used in petroleum, chemical, pharmaceutical, electroplating, environmental protection, water treatment, national defense, and other sectors.
In order to accomplish non-contact drive impeller rotation, the CQ magnetic pump is propelled by the inner magnetic steel rotor's magnetic field synchronous rotation, which combines the rotor and impeller into one unit. The magnetic pump totally removed the mechanical seal centrifugal pump's unavoidable run, risk, drip, and leakage of the illnesses because the liquid is encased in the static isolation sleeve, making it a kind of fully enclosed, no leakage pump type. Consequently, the following is a detailed introduction to the installation and use of CQ magnetic centrifugal pumps and the use of some of the precautions, let us together to understand it!
How to install and use CQ series magnetic pumps correctly?
1. The CQ series magnetic pump should be mounted horizontally rather than vertically, and the motor must be facing up to comply with particular requirements for vertical installation situations.
2. Open the suction pipe valve before starting if the pumping level is higher than the pump axis. A bottom valve must be installed in the pipeline if the pumping level is less than the pump axis.
3. Before using, make sure the stainless steel CQ series magnetic drive pump is free of jams and strange noises, that the motor blade rotation is flexible, and that all of the connecting components are tight.
4 Verify that the motor's rotational direction matches the CQ series magnetic drive pump steering mark.
5. After turning on the motor, gradually open the discharge valve and adjust it to the necessary opening degree once the pump starts operating normally.
6. Close the discharge valve first, followed by the suction pipe valve, before the pump cuts off.
What to pay attention to when using CQ magnetic pumps?
1. It is forbidden to idle because the cooling and lubrication of the magnetic pump bearings is the transported medium. Meanwhile, it is important to prevent the inches of no-load operation that can result from a power outage in the middle of the task and having to restart it.
2. The pump inlet needs to be filtered if the conveyed medium contains solid particles. For example, if the medium contains ferromagnetic particles, a magnetic filter needs to be added.
3. This CQ series magnetic drive pump in use should be operating at a temperature of no more than 40°C, and the motor's temperature rise shouldn't be higher than 75°C.
4. The temperature of the material to be carried and its suitability for the pump should coincide.
5. The transport liquid needs to be cleaned and drained after use since it is prone to precipitating and crystallizing the medium.
6. The CQ series magnetic coupled pump needs to be disassembled to examine the end face dynamic ring and bearing wear and tear after 500 hours of use. The bearings and axial dynamic ring need to be replaced if there is more than 0.5–1 mm of clearance between them and the shaft sleeve and 1.5–2 mm of axial movement of the impeller.
